Define Part-Based Initial Conditions

Use the Part tool to define initial conditions on all nodes (boundary + volume nodes) of selected solids.

1. From the Solution ribbon, click the Part tool.

   
   
   Figure 1.

2. Select solids.
3. In the microdialog, select variables for the initial condition then left-click in empty space in the dialog.
   The variable list should be open by default. If it is not, or if you want to go back adjust your selection, click .

   Tip: Select a variable and click to remove it from consideration.
4. Define initial condition parameters for each selected variable.
   For non-constant definition types, use the table and plot area to input data. Click in the Edit column to if you need to go back and edit the table/plot.
5. Optional: Right-click on a column heading to change the visible data in the microdialog.
6. From the guide bar, execute the command in the following ways:
   • Click to confirm your selection and remain in the tool.

     This allows you to continue creating instances and helps you visualize and edit instances with the legend.

   • Click to confirm your selection and exit the tool.