Sets a specific detail for all the connectors on the mark.
Syntax
*CE_SetSpecificDetail
ce_mark detail_type int_val dbl_val
Type
HyperMesh Tcl Modify Command
Description
Sets a specific detail for all the connectors on the mark.
Note: A connector must be in user control mode in order to edit the state.
Note: If the connector is in the unrealized state it can only be set to the failed
state.
Note: If the connector is in the realized, modified, failed or unconfirmed state it cannot be
set to the unrealized state.
Inputs
- ce_mark
- Mark of connectors.
- detail_type
- The number for the connector detail you are editing:
- Generic Connector Details:
- 1 = thickness (integer)
- 2 = user control (integer: 0 or 1)
- 3 = state (integer: 0 = unrealized, 1 = realized, 2 = failed, 3 = modified, 4 =
unconfirmed)
- Connector Line Details:
- 101 = spacing (double)
- 102 = density (integer)
- 103 = offset (double)
- 104 = half spacing (integer: 0 or 1)
- int_val
- Pass necessary integers values through this parameter.
- dbl_val
- Pass necessary double values through this parameter.
Examples
To change the thickness of the connectors on mark 1 from 2T to
3T:
*createmark connectors 1 "displayed"
*CE_SetSpecificDetail 1 1 3 0.0
To change the spacing for a connector with ID 10 and 11 created at a line to
5.0:
*createmark connectors 1 10 11
*CE_SetSpecificDetail 1 101 0 5.0