Stitch Surfaces

Use the Stitch Surfaces tool to stitch or unstitch adjacent and intersecting surfaces.

  1. From the Geometry ribbon, Edit tools, click the Stitch Surfaces tool.


    Figure 1.
  2. Optional: On the guide bar, click to define stitch options.
  3. Stitch or unstitch surfaces in the following ways:
    • Select surfaces to stitch in the modeling window then click Stitch on the guide bar.
    • Repair geometry by replacing edges and points.
      • Click-and-drag an edge to another edge, or click-and-drag a point to another point.
      • Select the point(s) to move, then click one of the selected points that you wish to retain and combine with the other selected points.
    • Left-click on a surface edge to advance its topology state from free to shared. Conversely, hold Shift while left-clicking to regress its topology state from shared to free.


Tip:
  • Use window selection to select multiple surfaces, and simultaneously stitch adjacent surfaces and intersecting surfaces. Adjust individual edges if needed.
  • Use the legend in the upper-left corner of the modeling window to assist you in finding edges. Edges are color coded by type. Show and hide an edge type by toggling its corresponding checkbox on and off, or quickly isolate an edge type by clicking Only.

Stitch Surfaces Tool

An overview of the Stitch Surfaces tool.



Figure 2.

Use the Stitch Surfaces tool to stitch or unstitch adjacent and intersecting surfaces.

Access
Go to Geometry > Stitch.

Options

Maximum stitching distance
Change the maximum distance across which the tool stitches edges together.
Optimize surface quality
Reconstruct geometry of selected surfaces to ensure consistency with the displayed topology.
Stitching method
Select a stitching method.
Stitch edges options
Select auto-stitching options
Within same component
Stitch created surfaces to neighboring surfaces that belong to the same component.
Across any component
Stitch created surfaces to all neighboring surfaces.
From attached to selection
Stitch created surfaces to surfaces attached to selected surfaces/edges.
From selection only
Stitch created surfaces to selected surfaces, or surfaces that have edges or vertices selected.
Stitch free edges only
Only stitch adjacent, non-shared edges.

Keyboard Shortcuts and Mouse Controls

To do this Press
Select surfaces. Click/drag points, edges. Left Mouse Click
Unstitch points, edges Shift + Left Mouse Click