This section consists of tasks that help tip the model and set up the drop
parameters.
Orientation
The Orientation task allows you to define the initial orientation of the part. You
can choose to rotate or translate the drop specimen using a base point, setting the
increments, in either degrees or model units, and defining the angles along the
global components of space. If you select C.O.G. (Center of Gravity) for the Base
Point, the model is automatically calculated and positioned. Figure 1.
Set Up Drop Test
The Set Up Drop Test panel allows you to input all the necessary control parameters
for the test, including the Ground Normal. Initial velocity is automatically
calculated to simulate a free fall based on the acceleration due to gravity input by
you. The default value is taken to 9810.0 mm/s2. You should enter the Drop Height
value. Figure 2.
