fe
Specify defaults for FE model solver types, version and file extensions.
Settings
- type
- Supported CAD file format.
- dyna
- File extension of LS-DYNA input file. You can add many extensions for this type.
- nastran
- File extension of Nastran input file. You can add many extensions for this type.
- pam
- File extension of PAM-CRASH input file. You can add many extensions for this type.
- radioss
- File extension of Radioss input file. You can add many extensions for this type.
- abaqus
- File extension of Abaqus input file. You can add many extensions for this type.
- optistruct
- File extension of OptiStruct input file. You can add many extensions for this type.
- connector
- File extension of Connector input file used for Spot weld check and Spot comparison function. If the type specified here and the actual file extension are not matching, the Check will not be executed.
- hypermeshcad
- The file extension of the HyperMesh file contains mesh only.
Import Settings
- fe-attached
- Parts with node sharing are organized into one part if the thickness of these parts is not the same. The organization will not be executed if the thickness of these parts are the same.
- fe-detach
- LH and RH parts will be separated. There will be two separated physical parts in case these two parts are organized into one part.
- importby
- While importing fe data into HyperMesh creating components by reading HyperMesh Comments or by reading HyperMesh information managed in the HyperMesh file.
- Include-stamping
- Reads stamping result information, such as element shell thickness, from the solver deck. This information will be used for mass calculation. Property thickness will be ignored if this option is ON.
- dummy-thickness
- Assigns a dummy thickness for the FE data. This dummy thickness is needed for CAD solid vs FE comparison in case no thickness exists from the original FE.